Oil and sludge separators are frequently used when light liquids (e.g. oil and petrol) might be released into the water flow, for example in car companies, engine overhauling, gas stations, carwashes, industrial areas parking lots, storage areas, environment parks and factory yard areas.
A coalescing filter should be applied when effluent is deposited on surface water or a higher efficiency is wanted.
FOR LIGHT MINERAL LIQUIDS WITH
KOMO CERTIFICATE NO. K2641
(RESIDUAL OIL CONTENT < 5 mg/l)
ESEP reinforced concrete coalescence separator for light mineral liquids with integrated sludge trap, series KMCI 7000, PA-KMCI 7000 and BPA-KMCI 7000 or without integrated sludge trap, series KMC 8000, PA-KMC 8000 or BPA-KMC 8000. The coalescence separator can also be equipped with an oil layer thickness and/or high level warning system which alerts you when the oil separator has reached it’s storage capacity. The oil separators are available in the standard capacities of 3 up to 120 l/s. Bigger/smaller capacities on request. The concrete cover either comes pre-assembled watertight to the basin, so that it is delivered as a whole, or it can be set by means of a liquid-tight rubber gasket.
Optional: provided with internal HDPE lining, tested by KIWA-TNO on chemical resistance in accordance with NEN-EN 858 – BRL 5251. Performance and hydraulic operation tested in accordance with NEN-EN 858, equipped with odour trap on the inlet side, strainer fitted on the outlet side of the sludge trap to retain course solids and automatic closure device on the outlet side, LGA certificate no. 4950177-14. Constructed and designed for static loads conform NEN-EN 858 – BRL 5251, concrete quality KOMO in accordance with NEN-EN 206-1 and NEN-EN 8005, minimum C35/45 environmental class XA3. Manhole cover cast iron-concrete combination in accordance with NEN-EN 124 class B 125 kN or class D 400 kN wheel pressure.